Power Rating : Available in 3kW to 8kW, 220V – 240V ac, 50/60Hz
Minimum Flow Rate : 2.0 litre/min
Maximum Pressure : Single point : 3.87kgf/cm² / 380kPa / 55psi
Multi Point : 6.12 kgf/cm² / 600kPa / 85psi
Temperature Control : Electronic Control
Water Connection : Diameter 15mm (½” BSP)
Dimension : 238mm X 388mm X 100mm (H)
Weight (Heater) : 3.4 kgs (Non Pump Model)
4.3 kgs (AC Pump Model)
4.0 kgs (DC Pump Model)
Heater Casing : ABS Plastic
AC Pump Electrical Rating : 120W, 220V-240V ac (For Pump Model Only)
( Motor)
DC Pump Electrical Rating : 36W, 24V DC (For Pump Model Only)
( Motor)
Color Variances
Cosy Blue Cosy Green Solid Blue Solid Menthol Green
Models Available:
* DecoStyle DS3 / DS5 (w/o ELCB)
* DecoStyle DS3E / DS5E (with ELCB)
* DecoStyle DS3P / DS5P (with Pump w/o ELCB)
* DecoStyle DS3EP / DS5EP (with ELCB & Pump)
* DecoStyle DS8 ESP (with ELCB & Silent Pump)
Features
1) Water Flow Sensor System
Flow Switch as Safety Device
A combination of reed switch and magnet jumper to sense the incoming water flow and to turn on the heater. This feature acts as a safety device to switch off the power to the heating element if water is not flowing through. Minimum Flow Rate to operate the heater - 2 liter/min.
2) Double Function Manual Reset Thermostat -prevents scalding
Important safety feature to cut off the heater power supply if water temperature exceeds 55ο C. Automatically resets when water temperature drops below approximately 44ο C.
A double function thermostat has double function, where in the event the temperature rise abnormally (exceeded 90ο C), the thermostat will be triggered and tripped permanently.
Cut Off Temperature Resetting Method
Primary 60ο C Auto, at 44ο C
Secondary 90ο C Manual button
With this feature, the following problem can be detected & prevent: -
Dry burnt of heating element and heater canister.
Malfunction of electronic/ electrical components.
Flow switch failure.
Triac Shorting.
Electronic Temp. Control Board failure.
The Purpose of DFT Thermostat
Others brand of Instant Water Heater uses Single Temperature Thermostat, in which 60ο C cuts off, the thermostat is auto reset at 44ο C, with this scenario, it went on few cycles (cut-out/ cut in), the water inside plastic tank become dry up, and steam went out from hose to hand shower, and eventually dry burnt occur, and heat will puncture through from plastic canister wall, and leakage will occur. The picture below showing plastic canister in which dry burnt has occur, and temperature inside plastic canister over heater, and cause canister to puncture, burnt as shown to photo on the right.
3) Built in Electronic Earth Leakage Circuit Breaker (ELCB)
Function – Safety Device to cut off the electrical supply if leakage of current occurs (15mA within 0.1sec). Thus preventing the user from electrocution. (See attached Keppen’s safety limit line)
The ‘TEST’ & ‘RESET’ button is to check on the ELCB functionality. The users advised to test the ELCB regularly. Press the ‘TEST’ button to stimulate the leakage of current inside the heater. Electric supply to Heater will break off immediately when the ‘TEST’ button is pressed.
Pop-Start Stop Valve with Regulator Valve & Filter for easy press “ON-OFF” water and the dual strainers is able to filter dirt so as to provide better shower sprays & longer life span of the heating system. < |
Stepless Electronic Power Control
Just by simply turning the Temperature Control from ‘LOW’ to ‘HIGH’, you can instantly adjust the water temperature to your preference. It is incredibly easy to use and because you are customizing just your exact temperature, you save energy too.
New 5 Spray Hand shower with matching shower accessories It incorporates a combination of 5 latest trend in shower sprays namely the Refreshing mist, Pulsation Jet, Ringo Spray, Maxi Spray & Misty Splash. |
Shower Pump
To boost up water flow rate in order to obtain comfort shower.
A.C Booster Pump D.C Silent Pump
Pump Control An innovative idea to let the user adjust the speed of the pump and to match with the optimum heat that comes from the heater. Suitable for use in high and low water pressure condition as the pump can be set to either ‘ON’ or ‘OFF’ -If incoming water pressure below 15psi, turn Pump Control to ‘On’ position. -If incoming water pressure over15 psi, turn Pump Control to ‘OFF’ position. |
Unique Design & Splash Proof Casing
The cover is made from plastic ABS-Resin and its unique design would be able to enhance the décor of the bathroom. And the designs comply with the splash proof requirements.
Multi Point Series
Centon Multi-Point Electric Instant Water Heaters are capable of heating the same quantity of water to higher temperature servicing multiple outlets at one time due to its innovative constructions with higher power element(s) and built-in booster pump.